asterisk users - Jul 2003 - Getting Started with Digium T100/E100 cards

Just purchased a couple of T100 and E100 cards in order to interface from
our company's proprietary system through a linux gateway.  I am new to
Asterisk and Digium.

After installing the T100 card, I went looking for drivers for this card.
Are the drivers built into the Asterisk application?  If so, how do I enable
the card through Asterisk?

Are there any good getting started documents for a newbie like myself?  I
have downloaded and read the Asterisk handbook, while helpful, it doesn't
answer all my questions.  (of course I could just be daft!)

Regards,

Sean Langley, P.Eng
Firmware Engineer
General Dynamics Canada
(403)730-1482
sean.langley@gdcanada.com

To enable any of TxxxP or ExxxP card you must compile the zaptel package
from cvs.

Then to enable the T100P or E100P you should load the wct1xxp module.

Then you can use the zttool (/sbin/zttool) to check the status of the cards
and of the spans you've configured in /etc/zaptel.conf

--
Stefano