hello
I try to manage a printer (Apple Lawerwriter 16/600 ) with cups but without
succes !!!
with cups web interface :
I "add a printer":
device = LPD/LPR Host or Printer
URI= lpd://mymachine/lp
Type= Apple
Model = Apple LaserWriter16/600 Foomatic/Postscript (Recommended)(en)
I try to print a testpage but without succes
- 'mymachine' is either in my dns and my /etc/hosts file
- no problem with " ping myprinter"
- no problem with " telnet myprinter 515"
- no problem with 'settings of myprinter"
LaserWriter 16/600 PS
TCP/IP Interface Information
Interface Status : Ready
PostScript Banner Page : Disabled
IP Address : xxx.yyy.zzz.aa
Subnet Mask : 255.255.255.0
Default Gateway : xxx.yyy.zzz.bb
Timeout Checking : Enabled
Ethernet Address : 09:01:08:05:7D:99
- but when I add myprinter and try to print a testpage, (loglevel debug ))
I have :
Remote host did not respond with command status byte after 300 seconds!
is there someone to help me?
thanks
gb.
_________________________________________________________________
MSN Hotmail : antivirus et antispam int?gr?s
http://www.msn.fr/newhotmail/Default.asp?Ath=f
Your URI is incorrect if your printer is a network printer the correct URI must be : lpd://myprinter ----------------------------------- St?phane PURNELLE stephane.purnelle@corman.be Service Informatique Corman S.A. Tel : 00 32 087/342467 samba-bounces+stephane.purnelle=corman.be@lists.samba.org a ?crit sur 19/01/2005 16:38:44 :> hello > > I try to manage a printer (Apple Lawerwriter 16/600 ) with cups butwithout> succes !!! > > with cups web interface : > > I "add a printer": > device = LPD/LPR Host or Printer > URI= lpd://mymachine/lp > Type= Apple > Model = Apple LaserWriter16/600 Foomatic/Postscript (Recommended)(en) > > I try to print a testpage but without succes > > - 'mymachine' is either in my dns and my /etc/hosts file > - no problem with " ping myprinter" > - no problem with " telnet myprinter 515" > - no problem with 'settings of myprinter" > > LaserWriter 16/600 PS > TCP/IP Interface Information > > Interface Status : Ready > PostScript Banner Page : Disabled > IP Address : xxx.yyy.zzz.aa > Subnet Mask : 255.255.255.0 > Default Gateway : xxx.yyy.zzz.bb > Timeout Checking : Enabled > Ethernet Address : 09:01:08:05:7D:99 > > - but when I add myprinter and try to print a testpage, (loglevel debug))> I have : > Remote host did not respond with command status byte after 300 seconds! > > is there someone to help me? > thanks > > gb. > > _________________________________________________________________ > MSN Hotmail : antivirus et antispam int?gr?s > http://www.msn.fr/newhotmail/Default.asp?Ath=f > > -- > To unsubscribe from this list go to the following URL and read the > instructions: https://lists.samba.org/mailman/listinfo/samba