My test is OK.....Thanks a lot....
There is a mistake in cups exemple web interface....
gb.
-----------------------------------
Your URI is incorrect if your printer is a network printer the correct URI
must be : lpd://myprinter
-----------------------------------
St?phane PURNELLE stephane.purnelle at corman.be
<https://lists.samba.org/mailman/listinfo/samba>
Service Informatique Corman S.A. Tel : 00 32 087/342467
samba-bounces+stephane.purnelle=corman.be at lists.samba.org
<https://lists.samba.org/mailman/listinfo/samba> a ?crit sur
19/01/2005 16:38:44 :
>/ hello
/>/
/>/ I try to manage a printer (Apple Lawerwriter 16/600 ) with cups but
/without>/ succes !!!
/>/
/>/ with cups web interface :
/>/
/>/ I "add a printer":
/>/ device = LPD/LPR Host or Printer
/>/ URI= lpd://mymachine/lp
/>/ Type= Apple
/>/ Model = Apple LaserWriter16/600 Foomatic/Postscript (Recommended)(en)
/>/
/>/ I try to print a testpage but without succes
/>/
/>/ - 'mymachine' is either in my dns and my /etc/hosts file
/>/ - no problem with " ping myprinter"
/>/ - no problem with " telnet myprinter 515"
/>/ - no problem with 'settings of myprinter"
/>/
/>/ LaserWriter 16/600 PS
/>/ TCP/IP Interface Information
/>/
/>/ Interface Status : Ready
/>/ PostScript Banner Page : Disabled
/>/ IP Address : xxx.yyy.zzz.aa
/>/ Subnet Mask : 255.255.255.0
/>/ Default Gateway : xxx.yyy.zzz.bb
/>/ Timeout Checking : Enabled
/>/ Ethernet Address : 09:01:08:05:7D:99
/>/
/>/ - but when I add myprinter and try to print a testpage, (loglevel
debug/)>/ I have :
/>/ Remote host did not respond with command status byte after 300 seconds!
/>/
/>/ is there someone to help me?
/>/ thanks
/>/
/>/ gb./
