R help - Dec 2005 - Problems in batch mode

Dear R-users,

I am trying to run some simulations in batch mode.  In an older version 
of  the program, I used

rterm --vsize=100M  --nsize=5000K --restore --save <input file> output
file,

however, in the new version R 2.2.0 , the  parameters vsize and nsize are 
ignored.

I can use the command memory.limit to increase memory, but I am not sure if 
this corresponds to vsize and nsize.

Does anyone know how can I set these quantities now?

Oh, please do your homework (in this case `An Introduction to R' and the 
NEWS file).

R 2.2.0 is not `new' (2.2.1 is), and those flags have been obselete for 
years (literally).

On Tue, 20 Dec 2005, Tomas Goicoa wrote:
>
> Dear R-users,
>
> I am trying to run some simulations in batch mode.  In an older version
> of  the program, I used
>
> rterm --vsize=100M  --nsize=5000K --restore --save <input file>
output file,
>
> however, in the new version R 2.2.0 , the  parameters vsize and nsize are
> ignored.
>
> I can use the command memory.limit to increase memory, but I am not sure if
> this corresponds to vsize and nsize.
>
> Does anyone know how can I set these quantities now?
-- 
Brian D. Ripley,                  ripley at stats.ox.ac.uk
Professor of Applied Statistics,  http://www.stats.ox.ac.uk/~ripley/
University of Oxford,             Tel:  +44 1865 272861 (self)
1 South Parks Road,                     +44 1865 272866 (PA)
Oxford OX1 3TG, UK                Fax:  +44 1865 272595