asterisk users - May 2010 - [Dahdi] "DAHDI_CHANCONFIG failed on channel 1"?

Hello

	I'm trying to install Dahdi through source code on a Fedora 13 host
to use an OpenVox PCI card with a single FXO port, but dahdi_cfg -vv
isn't happy.

1. After successfully running "make all; make install; make config", I
edited /etc/dahdi/system.conf thusly:

loadzone=fr
defaultzone=fr
fxsks=1

2. Then ran "dahdi_cfg -vv" which says:
-------------
DAHDI Tools Version - 2.3.0

DAHDI Version: 2.3.0
Echo Canceller(s): 
Configuration
=====================
Channel map:

Channel 01: FXS Kewlstart (Default) (Echo Canceler: none) (Slaves: 01)

1 channels to configure.

DAHDI_CHANCONFIG failed on channel 1: No such device or address (6)
-------------

3. So I ran "lscpi -v":

03:00.0 Communication controller: Tiger Jet Network Inc. Tiger3XX
Modem/ISDN interface
        Subsystem: Device b100:0003
        Flags: bus master, medium devsel, latency 64, IRQ 20
        I/O ports at a000 [size=256]
        Memory at e2000000 (32-bit, non-prefetchable) [size=4K]
        Capabilities: [40] Power Management version 2
        Kernel driver in use: netjet
        Kernel modules: wctdm, hisax, netjet

FWIW, when I run "modprobe wctdm" followed by "lsmod":

# lsmod
Module                  Size  Used by
wctdm                  31892  0 
dahdi                 180789  1 wctdm
netjet                 12563  0 
isdnhdlc                3343  1 netjet
crc_ccitt               1217  2 dahdi,isdnhdlc
mISDNipac              28346  1 netjet
mISDN_core             61414  3 netjet,mISDNipac

I'm not sure whether I should use the wctdm driver or this
"netjet"
driver which I've never seen before.
Could it be that "dahdi_genconf modules" added some ISDN-related items
that I don't need?

Thank you.

On Wed, 26 May 2010 17:17:08 +0200, Vincent <codecomplete at free.fr>
wrote:
>	I'm trying to install Dahdi through source code on a Fedora 13 host
>to use an OpenVox PCI card with a single FXO port, but dahdi_cfg -vv
>isn't happy.
More information, as I investigate:

# vi /etc/modprobe.d/dahdi.blacklist.conf 
#blacklist wct4xxp
#blacklist wcte12xp
#blacklist wct1xxp
#blacklist wcte11xp
#blacklist wctdm24xxp
#blacklist wcfxo
blacklist wctdm
#blacklist wctc4xxp
#blacklist wcb4xxp

# /etc/init.d/dahdi stop
Unloading DAHDI hardware modules: done

# /etc/init.d/dahdi start
Loading DAHDI hardware modules:
  wctdm:  [  OK  ]

/usr/share/dahdi/waitfor_xpds: Missing astribank_is_starting
No hardware timing source found in /proc/dahdi, loading dahdi_dummy
Running dahdi_cfg:  DAHDI_CHANCONFIG failed on channel 1: No such
device or address (6)
[FAILED]