asterisk users - Sep 2007 - Supermicro PDSME+ and TE110P

Hello all,

Has anyone use the Supermicro PDSME+ in combination with the TE110P 
successfully?
My experience so far is not very good.

I am running trixbox 2.0 but:

1) with zttool I am getting IRQ Misses. Don't seem to have IRQ conflict, 
but I am now running my SATA HD in DMA. And I am not able to set it in 
DMA(HIO... operation not permitted)
2) With zttool the Alarm is RED
3) When I do the loopback cable  Pin 1 going to 4 and Pin 2 going to 5, 
the status led does not turn green...

Any Hints? Ideas?

Thanks

K.

On Wed, 2007-09-19 at 13:01 +0000, kido wrote:
> Has anyone use the Supermicro PDSME+ in combination with the TE110P 
> successfully?
> My experience so far is not very good.
If you're having a motherboard compatibility issue with a Digium card
under warranty, you should contact the Digium support department and
they'll help you out.  

-- 
Jared Smith
Community Relations Manager
Digium, Inc.

The SME+ has a PCI bridge chip btw the 133MHz and 100Mhz slots so you might
want to try moving it to a slot on the other side of the bridge.  I believe
that card will work in any of the slots.

-----Original Message-----
From: kido [mailto:kido at cafe.tg] 
Sent: Wednesday, September 19, 2007 6:01 AM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: [asterisk-users] Supermicro PDSME+ and TE110P

Hello all,

Has anyone use the Supermicro PDSME+ in combination with the TE110P 
successfully?
My experience so far is not very good.

I am running trixbox 2.0 but:

1) with zttool I am getting IRQ Misses. Don't seem to have IRQ conflict, 
but I am now running my SATA HD in DMA. And I am not able to set it in 
DMA(HIO... operation not permitted)
2) With zttool the Alarm is RED
3) When I do the loopback cable  Pin 1 going to 4 and Pin 2 going to 5, 
the status led does not turn green...

Any Hints? Ideas?

Thanks

K.