Jeff Creek wrote:> I posted this in ZFS-Discuss. Eric Schrock suggested I ask in this forum.
>
> I am trying to test a new setup of NV74. I have set up the system with ZFS
boot. Everything works fine until I pull a drive. The system locks up when I try
to run any command e.g. zpool status. There is no communication with the server
from then on. It does not even respond to pings.
>
> Setup -
>
> Supermicro SC836TQ-R800 Chassis
> Supermicro X7DB8 Motherboard
> Supermicro SAT2-MV8 SATA controller
> Hitatchi Deskstar Harddrives 2 80GB Mirrored and 4 1 TB RaidZ
> Autoreplace set to ON
>
> If i push the reset button the system will come back up ok. I can then run
zpool status and find which drive is ''bad''. I would rather the
system keep functioning so I can just run the zpool status and then replace the
''bad'' drive.
>
> Is this setup not supported? Is there something I missed? What SATA
controller (if any) is supported for hot swap?
>
I believe that the device you have is a Marvell88SX6081, but without
prtconf output it is
hard to say. If you were to post the output from prtconf -pv and
prtconf -D it might
help figure out what is happening here. /var/adm/messages contents
might also be useful
as well as the output from cfgadm.
Regards,
Lida> Thanks,
>
> Jeff
>
>
> This message posted from opensolaris.org
> _______________________________________________
> storage-discuss mailing list
> storage-discuss at opensolaris.org
> http://mail.opensolaris.org/mailman/listinfo/storage-discuss
>
