Hi,
I am trying to install a broadcom ethernet controller into Dom0 (RHEL 5)...I
have compiled the broadcom sources with Xen kernel sources...
First, I have used the private pool in kernel memory mode, i.e. the module
will try to assemble a physically contiguous of memory using the kernel page
allocator. This memory block is then administered by the mpool allocation
functions. Note that once a system has been running for a while, the memory
fragmentation may prevent the allocator from assembling a contiguous memory
block, however, if the module is loaded shortly after system startup, it is
very unlikely to fail.
This leads to a kernel panic telling that the pgalloc function which
allocate memory ressources has failed...
Then I have tried to use the private pool in high memory mode, i.e. the
module will assume that unused physical memory is present at the high_memory
address, i.e. memory not managed by the Linux memory manager. This memory
block is mapped into kernel space and administered by the mpool allocation
functions. High memory must be reserved using either the mem=xxx kernel
parameter (recommended), or by hardcoding the memory limit in the kernel
image.
Thus, once Dom0 has booted, I have used the insmod function with a special
option to enable the private pool in high memory mode. Now, I can see that
the module is loaded but I get an error telling "no DMA memory
available"...
So my question is, How can I give DMA memory to this ethernet controller
into Dom0 ?
--
- - - - - - - - - - - - - - - - - - - - - - - - -
Emre ERALTAN
Elève ingénieur 3ème année
Electronique et Informatique Industrielle
ENSSAT
- - - - - - - - - - - - - - - - - - - - - - - - -
_______________________________________________
Xen-users mailing list
Xen-users@lists.xensource.com
http://lists.xensource.com/xen-users
