Hello,
i have been using xen 3.0 for some time now and with no problems. Now
that i had to set up a new machine i tried out 3.0.2. Once i noticed
that there are no longer different kernels for dom0 and domU, everything
worked out fine until I booted the first vm.
Now i have some strange issues, namely:
1. On every boot there is a long list of error messages, eg these:
8250: Unknown symbol uart_get_baud_rate
8250: Unknown symbol uart_resume_port
...
8250: Unknown symbol uart_write_wakeup
modprobe: FATAL: Error inserting 8250
(/lib/modules/2.6.16-xen/kernel/drivers/serial/8250.ko): Unknown
symbol in module, or unknown parameter (see dmesg)
2. Once booted, the network does not work and eth0 is not available.
3. Whenever i reboot or destroy the vm, on the next boot i get:
/dev/sda1 was not cleanly unmounted, check forced.
/dev/sda1: ***** REBOOT LINUX *****
/dev/sda1: 26210/512000 files (1.0% non-contiguous), 129316/1024000
blocks
fsck corrected errors on the root partition, but requested that
the system be rebooted (exit code 3).
Automatic reboot in 5 seconds.
My guess is that most of theses errors are, because the howto
(http://www.howtoforge.com/perfect_setup_xen3_debian) and configs I use
are for older versions of xen. Is there a list of what has changed with
the latest version with respect to install and vm configs?
Thanks,
Patrick
_______________________________________________
Xen-users mailing list
Xen-users@lists.xensource.com
http://lists.xensource.com/xen-users