I have a 9170 ups and would like to monitor the ups. by the serial port how can I do so. -------------- next part -------------- An HTML attachment was scrubbed... URL: http://lists.alioth.debian.org/pipermail/nut-upsdev/attachments/20061024/38b556cb/attachment.htm
Hi Glenroy, tis 2006-10-24 klockan 11:08 -0500 skrev Glenroy Thomas:> I have a 9170 ups and would like to monitor the ups. by the serial > port how can I do so. >If you mean a Powerware 9170, you may try the bcmxcp driver. As the ups is a 3phase you should try the svn trunk with driver version 0.11. It should run on the NUT-2.0.4 but would not show all meters. If this fails you may use the generic driver (contact closure). Look in the Users_guide_9170 for the port configuration (page 71 -72). Regards Kjell
Glenroy Thomas wrote:> > I have a 9170 ups and would like to monitor the ups. by the serial port > how can I do so.Hi Glenroy, you should start by looking at the list of supported hardware at http://www.networkupstools.org/compat/ It is sorted by manufacturer. If you see your device there, or a similar one, then chances are good that the listed driver will work. If your device is not on the list, but you get it to work, please let us know and we'll add it to the list. For instructions on how to set it up, see the installation instructions, either in the file INSTALL distributed with NUT, or at http://www.networkupstools.org/doc/. -- Peter