Nut upsdev - Aug 2006 - Re: [Nemo-devel] nuts status page

Adam: Thanks for putting up this page.  But something is wrong.  In 
particular, our Powerware 9135 is a three phase UPS system with THREE 480 
volt outputs.  So the displayed voltage is not correct -- in fact there 
should really be THREE voltages displayed, all around 480v.

Nut developers: I am copying the NUT mailing list to see if anyone can 
suggest how to fix this.  NUT developers, see the following page to see 
the problem: http://nemo.phys.uwm.edu/cgi-bin/upsstats.cgi .  Instead of 
displaying a single voltage of 276 VAC we should see three voltages of 
around 480 VAC.

Cheers,
 	Bruce



On Thu, 3 Aug 2006, Adam Miller wrote:
> Hi,
>  You can check the status of the ups in the nemo room by going to the 
> following link.
>
> http://nemo.phys.uwm.edu/cgi-bin/upsstats.cgi
>
>
> Cheers,
> Adam
> _______________________________________________
> Nemo-devel mailing list
> Nemo-devel@gravity.phys.uwm.edu
> http://gravity.phys.uwm.edu/mailman/listinfo/nemo-devel
>

Hi Bruce,
tor 2006-08-03 klockan 11:59 -0500 skrev Bruce Allen:
> Adam: Thanks for putting up this page.  But something is wrong.  In 
> particular, our Powerware 9135 is a three phase UPS system with THREE 480 
> volt outputs.  So the displayed voltage is not correct -- in fact there 
> should really be THREE voltages displayed, all around 480v.
> 
> Nut developers: I am copying the NUT mailing list to see if anyone can 
> suggest how to fix this.  NUT developers, see the following page to see 
> the problem: http://nemo.phys.uwm.edu/cgi-bin/upsstats.cgi .  Instead of 
> displaying a single voltage of 276 VAC we should see three voltages of 
> around 480 VAC.
> 
> Cheers,
>  	Bruce
Yes this can be fixed.

Are you using the bcmxcp driver or is it monitored by snmp?

Regards
Kjell