Hi,
we also got one V2 TE405P card. It works fine now. At the moment we use for
bridging the Pri to our old PBX.
You must use zaptel, libri and asterisk v 1.0.8 or higher. We use 1.0.9 at the
moment.
zaptel:
after make; make install i also executed make config. This copies the correct
startup script to /etc/init.d/zaptel. Without this it also didn't worked for
me.
Master Abi wrote:> Hi
>
> I got the 2nd Gen firmware upgraded on the TE405P. I recompiled after
> putting in the upgraded board but did not change any conf, but the spans
> become active but will not come up.
>
> I guess I am missing something or are the any changes to the
> zaptel/libpri software that is required. I cannot find any info about
> this or does this new firmware only work with latest CVS. I am using
> 1.0.9 with 2.6.12 kernel
>
> Zapata Telephony Interface Registered on major 196
> Found TE4XXP at base address fdfff000, remapped to f8928000
> TE4XXP version c01a0164, burst ON, slip debug: OFF
> TE4XXP running with work queues.
> FALC version: 00000005, Board ID: 00
> Reg 0: 0x364e9400
> Reg 1: 0x364e9000
> Reg 2: 0xffffffff
> Reg 3: 0x00000000
> Reg 4: 0x00000001
> Reg 5: 0x00000000
> Reg 6: 0xc01a0164
> Reg 7: 0x00001f00
> Reg 8: 0x00000000
> Reg 9: 0x00ff0000
> Reg 10: 0x00000000
> TE4XXP: Launching card: 0
> TE4XXP: Setting up global serial parameters
> Found a Wildcard: Wildcard TE405P (2nd Gen)
> eth0: link up, 10Mbps, half-duplex, lpa 0x0000
> About to enter spanconfig!
> Done with spanconfig!
> About to enter spanconfig!
> Done with spanconfig!
> Unassigning channel 0/1!
> Unassigning channel 0/2!
> Unassigning channel 0/3!
> Unassigning channel 0/4!
> Unassigning channel 0/5!
> Unassigning channel 0/6!
> Unassigning channel 0/7!
> Unassigning channel 0/8!
> Unassigning channel 0/9!
> Unassigning channel 0/10!
> Unassigning channel 0/11!
> Unassigning channel 0/12!
> Unassigning channel 0/13!
> Unassigning channel 0/14!
> Unassigning channel 0/15!
> Unassigning channel 0/16!
> Unassigning channel 0/17!
> Unassigning channel 0/18!
> etc...
>
> This was working for 10 months before the upgrade.
>
> Master
>
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users@lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
> http://lists.digium.com/mailman/listinfo/asterisk-users
>
>