asterisk users - May 2005 - BRI and PRI together possible?

Hi,

I plan to setup an * Server with a TE10P PRI card as E1 and a BN4S0 4 Port
BRI card in one box.

I tried it first with the bristuff drivers from Junghanns. The BRI card
worked fine alone, but as soon as I load the zaptel driver for the 
TE110P the BRI card says, that the port is down.

So I tried it with mISDN. But it seems that this stuff is still unstable
(Asterisk refuses to start at first when I load the zaptel and wcte11xp
module first and then the mISDN module, the other was around, asterisk
starts.). The wcte11xp driver seems to confuse the mISDN stuff - sometimes.


Is there any stable way, or as someone experience with this two cards in one
box?


Regrads,
Henry

Hi, 
> -----Original Message-----
> I tried it first with the bristuff drivers from Junghanns. 
> The BRI card
> worked fine alone, but as soon as I load the zaptel driver for the 
> TE110P the BRI card says, that the port is down.
> Is there any stable way, or as someone experience with this 
> two cards in one
> box?
Yes it can be done (at least with 'real' Junghanns QuadBRI cards, I
don't
know about the BN card, but I suppose it should work).

One thing to note is the way in which modules are loaded. Make sure you
don't use modprobe in this scenario, but insmod. This is because with
modprobe ztcfg is run after loading the first driver module. This can cause
some problems. So insmod all modules, then run ztcfg manually (or from your
own script).

Florian