Hello.
I have been working on getting my asterisk box to connect to a lucent
definity PBX using a T100p. I connected it to a t1 port on the lucent box
and ran a T1 crossover cable to the t100p. I have asterisk setup with a
voicepulse account for outbound and inbound dialing. On the lucent pbx I
matched the configs of a working channelized MCI t1. The only thing asterisk
is doing is acting as a voip gateway. Everything works ok with only one
issue. When someone makes a call outbound and hesitates on dialing the
numbers, asterisk only picks up a partial number. It doesn't wait until the
person dialing finished dialing the full number. If the person dials the
number without any delay the call goes through. On the asterisk console I
see the partial phone numbers when this happens.
How does this type of setup work. Is this a lucent issue or an asterisk
issue. Does the lucent pbx just open a channel, send digits and them the
asterisk box has dialplan time out or is the lucent pbx to wait until it
sees all the numbers before sending it to the asterisk box.
Any help will be appreciated.
Thanks
John Bittner
Zapata.conf
[channels]
;
; T100P plugged into Lucent Definity
;
context=voicepulse-outgoing
signalling=em_w
group=1
channel =>1-24
rxwink=300
usecallerid=yes
callwaiting=yes
echocancel=yes
rxgain=0.0
txgain=0.0
immediate=no
callerid=asreceived