Is there anything special I need to know in Dom0 when trying to use
setpci to enable and move the boot ROM on an Ethernet adapter? I am able
to enable the ROM, but it is in the same place as the RAM, and I can''t
seem to move it.
I have 1Gb of RAM, which I believe is mapped from 0x00000000 to
0x3fffffff, but the ROM is set to 0x3ff00000, and using something like:
setpci -s 01:0b.0 ROM_ADDRESS=48000000
doesn''t change anything, while:
setpci -s 01:0b.0 ROM_ADDRESS=48000001
enables it, but leaves it at the same address (and still behind RAM so I
can''t get to it).
Previously, before I overwrote the flash, it was mapped to 0x40000000
and was readable.
Thanks
James
_______________________________________________
Xen-users mailing list
Xen-users@lists.xensource.com
http://lists.xensource.com/xen-users
