asterisk users - Apr 2006 - Pinouts for T1/E1 crossover cable WAS "RE: whatcable to connect a legacy PBX to a TE410P ?"

I have used cross-connect wire from the spool to make T1 crossover cables with
RJ45 ends.  All that matters is that pin one goes to four and two goes to five
on both ends.

________________________________

From: asterisk-users-bounces@lists.digium.com on behalf of Andrew
Sent: Sat 4/22/2006 2:51 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: Pinouts for T1/E1 crossover cable WAS "RE: [Asterisk-Users]
whatcable to connect a legacy PBX to a TE410P ?"



Alexander Lopez wrote:
>I have not in my experience seen any problems with using a Good Quality
>Cat5 vs. Cat 3 (telco standard) cable for X-connects.  YMMV, but you
>should be fine. As far as the shielding goes, I use UTP cables and
>Connectors all the time and some of my X-connects run over 100 feet
> 
>
I have used cat-5 for everything communications. serial printers, dumb
terminals, DS1  and even 10/100 ethernet. :-) It's easier to have it
installed as a network jack and then use for whatever you need.

...

Andrew McRory
LinuxSystems
Tallahasse, FL
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --

Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users


-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/ms-tnef
Size: 4773 bytes
Desc: not available
Url :
http://lists.digium.com/pipermail/asterisk-users/attachments/20060422/669fcdfb/attachment.bin