The TE410P should run fine under both Redhat 9 and Fedora Core 1. My first
question is: Are you running a new CVS version? Maybe there have been bugs
introduced with all of the recent changes. I'm running under December
versions - works ok, except for problems experienced under very heavy call
loads, that have been discussed on here many times (still not resolved)
But it also sounds possible that you're having basic PRI problems of some
sort, perhaps clock sourcing or something similar. Please share your
zaptel.conf and zapata.conf, including which span is connected to what.
Regards
Scott
Scott M. Stingel
Emerging Voice Technology Inc.
Palo Alto, California and London, England
Email: scott@evtmedia.com
URL: www.evtmedia.com
-----Original Message-----
From: asterisk-users-admin@lists.digium.com
[mailto:asterisk-users-admin@lists.digium.com] On Behalf Of David Gomillion
Sent: Monday, January 26, 2004 7:43 AM
To: asterisk-users@lists.digium.com
Subject: [Asterisk-Users] TE410P on Redhat 9
I am the proud new owner of a TE410P, and installed it on a RedHat 9 box.
After compiling just fine, running like a champ in tests, and having my
extensions.conf configured to taste, I went ahead and did a live beta test
this past weekend.
The phone system stopped responding 3 times. The first time, I got into the
asterisk console, vi -rvvvvv. I didn't see anything too out of the
ordinary, except for lots of messages that all of the lines were busy (even
though no calls were up and I have 2 PRI's). I thought it odd, but since I
had been tweaking a config file or two, I didn't think too much about it. I
just stopped * and Zaptel, and then restarted them, in reverse order. And
everything was beautiful.
THen, on Saturday night, around 7:00 PM, I tried to call in again (I was
calling in every half hour to make sure it was working), it had died. I was
in a bad mood, and just restarted the same as I had the day before to get it
over with.
Finally, on Sunday morning, I tested the phone, and at about 8:00 am * was
not responding. I logged in, again with 5 v's, and saw an error message to
the effect "Span 2 is up". Span 2 is a PRI from * to my Norstar MICS,
using
a cross-over cable. I think the LBO and signalling are correct, because
calls went through it just fine until the 3 times mentioned above.
I started by doing a reload, which changed nothing, then a restart when
convenient, which changed something... Now, Span 1, 2, 3, and 4 all gave the
message that they were up, about 1x per 2 seconds, each. Every 5 or 6
messages I would see that one of the spans was down, but most of the
messages were just about being up.
I immediately stopped Asterisk and Zaptel, restarted Zaptel, then Asterisk,
and everything ran fine through this morning, when I took Asterisk out of
the loop (planned end of the beta test).
Does anyone have any ideas what might be causing this, and how to diagnose
without taking our main phone switch down? I have access to a PRI, but it
has no phone numbers that ring into it, so I can connect to real network
equipment and make calls, but cannot receive any.
Thanks,
David Gomillion
_______________________________________________
Asterisk-Users mailing list
Asterisk-Users@lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users