zfs discuss - Feb 2010 - Help with itadm commands

Hi - I''m trying to create an iscsi targe and go thru the motions of
making the following LUN''s available - I am not able to run the
command: itadm create-target as I get the following error: bash: itadm: command
not found

I need to get the following dirve seen by vmware 

0. c7t0d0 <Areca-ARC-1260-VOL#00-R001-279.40GB>
          /pci at 0,0/pci8086,29f1 at 1/pci8086,370 at 0/pci17d3,1260 at e/disk
at 0,0
1. c7t0d1 <Areca-ARC-1260-VOL#01-R001-279.40GB>
          /pci at 0,0/pci8086,29f1 at 1/pci8086,370 at 0/pci17d3,1260 at e/disk
at 0,1
2. c7t0d2 <Areca-ARC-1260-VOL#02-R001-279.40GB>
          /pci at 0,0/pci8086,29f1 at 1/pci8086,370 at 0/pci17d3,1260 at e/disk
at 0,2


any help would be greatly appreciated
-- 
This message posted from opensolaris.org

The iSCSI COMSTAR Port Provider is not installed by default.
What release of OpenSolaris are you running?
If pre snv_133 then:

  $ pfexec pkg install  SUNWiscsit

For snv_133, I think it will be:

  $ pfexec pkg install  network/iscsi/target

Regards
Nigel Smith
-- 
This message posted from opensolaris.org