Hi, I hope someone can help or at least point me in the right direction with a problem I am having. I have a 4 disk ZFS stripe set. It was supposed to be RAIDZ but I messed up and have only just noticed. One of the disks has developed a read error so I have stuck a new drive in and run zpool replace data c3t1d0 c3t5d0 This all ran fine for a couple of hours until the resilver hit 82%. dmesg now shows 4 errors occuring on the drive which are all listed as Retryable. It now appears that the resilver has stalled. Running zpool status gets as far as scrub: resilver in progress but stops before showing the disks in the pool. The zpool status process is now unkillable. If it makes any difference the machine is a Supermicro with an 8 port SATA card using the Marvel chip which I think is used in some of the Sun machines. Is there anything I can do to tell the system to just carry on with the next blocks? Obviously I expect to loose some files here where the bad blocks are. What I was expecting though was that the resilver would carry on copying everything possible onto the new drive. Not just lock up dead! Any help or suggestions would be greatly appreciated. Thanks David -- This message posted from opensolaris.org