I have installed Centos 5.5 + Xen. my server has two network cards: *eth0* -
for local trafic and *eth1* - for global internet trafic. I have 5 usable
IPs. "ip ad" comand show the following eth1 addresses
eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue
link/ether 00:25:90:30:78:a3 brd ff:ff:ff:ff:ff:ff
inet xx.xx.xx.58/29 brd xx.xx.xx.63 scope global eth1
inet xx.xx.xx.59/29 brd xx.xx.xx.63 scope global secondary *eth1:0*
inet xx.xx.xx.60/29 brd xx.xx.xx.63 scope global secondary *eth1:1*
inet xx.xx.xx.61/29 brd xx.xx.xx.63 scope global secondary *eth1:2*
inet xx.xx.xx.62/29 brd xx.xx.xx.63 scope global secondary *eth1:3*
question is:
how to use it correctly in XEN with bridge mode? and what to write in domU
config file for* vif = ["....."]*
*my xen-config.sxp setup*
(network-script netwokr-bridge)
(vif-script vif-bridge)
for example if I use IP address xx.xx.xx.59 in windows it says address
already in use.
thank you for any direction or if someone can post their setup for this type
of network will help a lot!
_______________________________________________
Xen-users mailing list
Xen-users@lists.xensource.com
http://lists.xensource.com/xen-users
