You probably miss (vif-script vif-route) in your Xend configuration file.
Also, to configure Xen guest configuration file in routing mode is a little
tricky. Make sure you have specify the gateway as your dom0''s IP
correct and
also specify the same IP in your running guest as in your guest
configuration file.
Good luck!
~wenjin
On Fri, May 1, 2009 at 12:42 PM, Siddharth Wagh
<siddharth.wagh@gmail.com>wrote:
> I made the necessary changes in xend-config.sxp, network-route and guest
> config files to switch over to routing mode (as suggested in "Running
Xen"
> book). I created guest VMs and I restarted xend. But when I checked
> ifconfig, but it still shows me the bridge configuration. Can anyone tell
me
> what I am missing here??
>
> Thanks & Regards,
> Siddharth Wagh
> MS, Electrical & Computer Engineering
> Rutgers University, NJ
> Web: http://www.eden.rutgers.edu/~swagh/
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@lists.xensource.com
> http://lists.xensource.com/xen-users
>
_______________________________________________
Xen-users mailing list
Xen-users@lists.xensource.com
http://lists.xensource.com/xen-users