I currently have many HP blades(Intel) running OpenSuse 10.3 64bit and Xen 3.1 from the suse package management system. Today, I installed Suse 11.0 64bit on two blades, and then installed Xen 3.2.1 from the pakage management system. When I reboot, the xen kernel begins to load, but then gets stuck and sits at a blinking cursor. The last messages printed to the screen are: 00:09: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A iTCO_vendor_support: vendor-support=0 ACPI: Power Button (FF) [PWRF] ACPI: ACPI0007:01 is Registered as cooling_device1 ACPI: ACPI0007:02 is Registered as cooling_device2 ACPI: ACPI0007:03 is Registered as cooling_device3 ACPI: ACPI0007:04 is Registered as cooling_device4 ACPI: ACPI0007:05 is Registered as cooling_device5 ACPI: ACPI0007:06 is Registered as cooling_device6 ACPI: ACPI0007:07 is Registered as cooling_device7 Broadcom NetXtreme II Gigabit Ethernet Driver bnx2 v1.7.4 (February 18, 2008) ACPI: PCI Interrupt 0000:03:00.0[A] -> GSI 16 (level,low) -> IRQ 16 _ The cursor will sit here and blink forever. Any idea what this could be or where to go from here? _______________________________________________ Xen-users mailing list Xen-users@lists.xensource.com http://lists.xensource.com/xen-users