IBM xseries 306m Slackware 10.2 2GB of RAM 3.2Ghz Xeon Scsi drive:WDC WD1600JS-23M Rev: 03.0 I installed xen 3.0.3 and specified a dom0 and a domU kernel in the Makefile. Everything built and installed fine and I can boot the system but when I try to run vgscan I get the error: "vgscan -- LVM driver/module not loaded?". So I tried to load the module, ''modprobe dm_mod'' and it says it is not found. I checked the kernel using a ''make menuconfig'' and found the device mapper module statically compiled into the kernel. So the module is compiled into the kernel but I have no lvm support and the only module I can see that is loaded is agpgart, that is the only module that loads. Has anybody seen this and know how to get around it? Do I need an initrd to make xen3.0.3 to work? Thanks for any advice, Jon _______________________________________________ Xen-users mailing list Xen-users@lists.xensource.com http://lists.xensource.com/xen-users