Has anyone successfully gotten X to work inside a domU (by working directly with a graphics card, not with vnc or equivalent)? Is this possible? I have a computer with two graphics cards (both PCI Express). My dom0 uses the primary card (PCI 05:00.0; the card used at boot by the BIOS); I delegated the second card (PCI 04:00.0) to a domU. I can run X in the dom0, but in the domU, the following happens: $ X -novtswitch -sharevts vt0 ... (==) Using config file: "/etc/X11/xorg.conf" (EE) end of block range 0x1fff < begin 0xbaee0000 PCI: Enabling device 0000:04:00.0 (0000 -> 0002) ACPI: PCI Interrupt 0000:04:00.0[A] -> GSI 16 (level, low) -> IRQ 16 Fatal server error: xf86MapVidMem: Could not map framebuffer (0x000a0000,0x200000) (Bad address) ACPI: PCI interrupt for device 0000:04:00.0 disabled Interestingly, the device is "04:00.0" in dom0, but it shows up as "00:00.0" in this domU (in lspci). Any thoughts? Debugging suggestions? Pointers to instructions? Thanks, Adam _______________________________________________ Xen-users mailing list Xen-users@lists.xensource.com http://lists.xensource.com/xen-users