similar to: SIP Phone to use with *

Use oh323. Download the openh323 and pwlib tarballs from openh323.org Follow Jeremy's instructions in the /asterisk/channels/h323/ directory EXACTLY! good luck Regards, Sean Langley, P.Eng Firmware Engineer General Dynamics Canada (403)730-1482 sean.langley@gdcanada.com > -----Original Message----- > From: Senad Jordanovic [mailto:senad@cwcom.net] > Sent: Friday, September 12,

Hello all, Please forgive me if this sounds a little (or a lot) ignorant as I am very new to asterisk. Right now I have two pc's connected back to back through an E100 card running asterisk. I have openh323 running as well and I am able to route calls through the E1 line. Next up I would like to be able to register asterisk with a gatekeeper. On another computer is running openGK. Using

Is anyone using the subject phone without the proprietary call setup equipment? How do you configure this phone to use the * pbx? I am hoping to go out and buy a couple of phones but the dealer here says I need to spend another $15K or so for the call manager equipment. Regards, Sean Langley, P.Eng Firmware Engineer General Dynamics Canada (403)730-1482 sean.langley@gdcanada.com

Hi, I have just got my SNOM 200 to start doing some real testing with *.. I am trying to use the GSM codec but the quality is really bad, Is that normal? does anyone actually use GSM?? Also are there any 'gotcha's' that I need to look out for so I don't spend hours trying to get somthing working that really doesn't work anyway.. Thanks.. later.. --

Hi, Has somthing radical happened to the way sip traffic is handled?? I was just doing some testing and where G.711 used to use about 84kb/s of bandwith its now using between 150kb/s and 190kb/s.. The lowest I could get it to in the Snom was 160kb/s and 75 packets per second which was by setting the packet size to 40ms (was 20ms) in the Snom codec setup.. I am running a CVS version from

Just purchased a couple of T100 and E100 cards in order to interface from our company's proprietary system through a linux gateway. I am new to Asterisk and Digium. After installing the T100 card, I went looking for drivers for this card. Are the drivers built into the Asterisk application? If so, how do I enable the card through Asterisk? Are there any good getting started documents for a

Hello I am a newbie to Asterisk. We have set up Asterisk on a PC with Redhat 9.0. We have installed H323 openphone on our PC's. We are wondering what a gatekeeper does. It seems we need one but what I have seen in this group is that a gatekeeper must be installed on another box on the network. As all our PC's on the network use Microsoft OS is there a free gatekeeper software for

I am looking at phones for my asterisk system and seem to have a problem. The only Power over Ethernet phones I can find that support the IEEE standard are 3com. Cisco uses its own proprietary ( and is expensive to boot ), snom has a different but equally non-IEEE method, and i'm havent found another phone that I'm confident can do the job for our office. Whats a good high quality ip

Hello! I have finally ordered some Asterisk hardware: the TDM DevKit. However, I want to use VoIP phones (or possibly adapters) for remote users. I would like to get some suggestions on which phones to buy. I'm hoping that some of you with real experience might be able to help me out! Here are the features that are important to me: * While these phones are initially going to be

Does anyone have a recommendation for a good SIP phone with a busy lamp field? I need my operator to be able to see extension status for about 20 extensions and transfer via HOLD + extension button. I've got a pair of SNOM 360s with the sidecar, but I'm very disappointed with them. The buttons are cheap and rubbery like a Sipura 841, the handset cord is short and cheap, the audio quality

Hi, I am looking for hardware sip phone with very good sound quality. Can anyone recommend ? I use to have Grandstream Budge-Tone 100 but I feel that the sound is not very satisfactory and volume too soft Regards ASLAY

Hello I need to buy IP Phones to work with Asterisk, and I'm in doubt between Snom and Cisco Phones. Can you gurus, please, give me your impression of these 2 brands? I need to focus more in SIP and Asterisk compatibility and less in pricing (yes, I know the Cisco are more expensive). Are there any features that Snom has, that Cisco doesnt? And are these features important? Thanks Joao

Hi, after finally getting my testsystem to work well I'm planning to buy some hardware. Now I was wondering what the advantages / disadvantages of using a Wildcard TDM400P solution over using real sip phones like the snoms is? The only thing I came up with is that the Snoms can use a LDAP adressbook on the server. What about calling a sip adress like person@server.com. Can this be done by

Hi, everyone: I'm in the processing of deciding what IP phones we should use with our Asterisk server, and I wanted to get feedback from the user community on the quality, reliability and ease of operation of Snom phones. What do you have to say about these phones? Are there other phones you'd suggest along with or instead of Snom? Thanks, -Stephen-

Anyone able to point me the right direction for the following would be helpful. I have a client that needs to keep detailed time for how long their Customer Service Reps. Spend on different subject with the customers. i.e. All CSR's are trained to take all types of calls. For regulatory reasons they have to keep track of how long they spend talking to a customer about different

Hello, I'm looking for IP phones with at least 10 or so speed dial buttons. Can you recommend something which works with Asterisk and does not cost fortune? An option can be analog phone combined with ATA adapter. So hints for good analog phones (EU) are welcomed as well. Thank you, -- David -------------- next part -------------- An HTML attachment was scrubbed... URL:

Hi All I have a snom 200 phone here which works perfectly when using the handset to playback the voicemail messages etc. However when I play back the voice using the speakerphone it sounds choppy. Anyone had this problem before? Regards Mark

Hi, I have asterisk functioning as SIP to H.323 gateway for local SIP endpoints and I have H.323 to PSTN gateway (Lucent MAX TNT) connecting my LAN VOIP to PSTN via PRI. Everything works fine with one exception. I seem to be unable to figure out why I cannot hear PSTN intercepted announcement ("number is not in service" etc.) when I'm calling a disconnected number through

Hello, I would like to buy a SIP IP phone, but I don't know wich one to choose... Can you tell me wich IP Phone is known to work with Asterisk please. I've seen the Cisco 7940, but I don't know if it works, and how expensive is it ? I'm french, so if you know some french resellers, tell me. Thanks a lot, ---------------------- Fabrice Tereszkiewicz Sawadka.org

Matching regular expressions Dear useRs! I have the following problem. I would like to find objects in my environment that have two strings in it. For example, I might want to find objects that have in their names "MY" and "TARGET". I do not care about the ordering of these two substrings in the name, neither what is in front, behind or between them, the only thing important