I have a windows NT4 client with a deskjet printer. I can connect to the printer using cups without any problem. I have also been able to make a printer share where I can connect to it via a W2K client by loading the drivers on the W2K client. (W2K->Samba->NT4). Then I created another share with the raw feed setting and tried to load the drivers to the Samba Server via the Windows APW. When I initially did this everything appeared to work fine. Until I went to another W2K client, when I clicked on the printer share it asked me if I wanted windows to set it up, I clicked yes and everything seemed to work fine. Then I tried to go to properties and received the error message "Function address 0xXXXXX caused a protection fault (exception code 0xc0000005). Some or all of the property pages may not be displayed". I then looked around and found some info that this was a problem with Samba 3.0.0 that was fixed in 3.0.1. Found 3.0.10 and installed it. Created a new printer share and tried to install the drivers, now at the very end of the installation I get an error message "Explorer.exe has generated error and will be closed by Windows. You will need to restart the program". When I go to properties for that printer share and try to load the printer I get the same error message as before with 3.0.0 installed. I have checked the drivers in /etc/samba/drivers/3 and they all appear to be there ( I compared the files to those on the "Windows 2000 Printer Test Page"). Should I delete the drivers and try again? What would be the best way to delete the drivers? There is also a shared printer that is still showing which I had deleted in cups, but it is still there. What would be the method for making sure this is properly deleted( I had about 3 others which I created and deleted during this testing and they do not show up anymore ).