Hi all,
I just set up my bind server. But I keep on receivind 2 error messages
in my syslog. Those are:
/etc/bind/named.conf:55: parse error near 'view'
/etc/bind/named.conf:103: parse error near 'view'
I cannot figure out why I get these messages, so if anyone could give me
a hand...!!
This is the part of my named.conf
view "internal" {
match-clients { 127.0.0.0/8; 192.168.0.0/24; };
recursion yes;
view "external" {
match-clients { any; };
recursion no;
If I just comment this parts out I works without ginving me any error
messages in syslog, but I don't think this is how it should be.
Thanks in advance,
Ronald Roeleveld.
Hi all, I was just wondering if I should spend $$ (my company's of cos) on a NetApp filer... OR I just get one of the Dell 3650 doing nothing in the corner with RAID5 and run Samba as a fileserver? Anyone got any benchmarks to compare the two? Is NetApp as good as its advertised? Any comments on this setup is welcomed Regards Darren
One reason you might consider _not_ buying a NetApp appliance is that NetApp _does_not_ support Samba as a domain controller. Clark -----Original Message----- From: darren [mailto:teodarren@myrealbox.com] Sent: Wednesday, October 09, 2002 8:49 PM To: samba@lists.samba.org Subject: RE: [Samba] parse error near 'view' Hi all, I was just wondering if I should spend $$ (my company's of cos) on a NetApp filer... OR I just get one of the Dell 3650 doing nothing in the corner with RAID5 and run Samba as a fileserver? Anyone got any benchmarks to compare the two? Is NetApp as good as its advertised? Any comments on this setup is welcomed Regards Darren -- To unsubscribe from this list go to the following URL and read the instructions: http://lists.samba.org/mailman/listinfo/samba