R help - Jun 2009 - using lattice dotplot with two equal data points

I'm wondering if I am dealing with a limitation in lattice.  It's
probably due to my own limitations though.  

I'm working with a lattice dotplot.  The x-axis is set at "free". 
In
one panel, there are only two data points that have equal x-axis values.
Since no range exists, lattice isn't plotting those points. It reports: 

"Error Packet using 6 
'x' and 'units' must have length>0" 

Is there a way that I can get it to plot anyway?  Do I have to
manipulate that one panel?  Any suggestions on how to do that?  I'd
rather have some sort of automatic backup range set instead.

David Chosid
Massachusetts Division of Marine Fisheries
1213 Purchase St., 3rd Floor
New Bedford, MA 02740
508-990-2860 x140
email: david.chosid at state.ma.us

On Fri, Jun 12, 2009 at 10:54 AM, Chosid, David
(FWE)<David.Chosid at state.ma.us> wrote:
> I'm wondering if I am dealing with a limitation in lattice.  It's
> probably due to my own limitations though.
>
> I'm working with a lattice dotplot.  The x-axis is set at
"free".  In
> one panel, there are only two data points that have equal x-axis values.
> Since no range exists, lattice isn't plotting those points. It reports:
>
> "Error Packet using 6
> 'x' and 'units' must have length>0"
>
> Is there a way that I can get it to plot anyway?  Do I have to
> manipulate that one panel?  Any suggestions on how to do that?  I'd
> rather have some sort of automatic backup range set instead.
A reproducible example please.

-Deepayan
>
> David Chosid
> Massachusetts Division of Marine Fisheries
> 1213 Purchase St., 3rd Floor
> New Bedford, MA 02740
> 508-990-2860 x140
> email: david.chosid at state.ma.us
>
> ______________________________________________
> R-help at r-project.org mailing list
> https://stat.ethz.ch/mailman/listinfo/r-help
> PLEASE do read the posting guide
http://www.R-project.org/posting-guide.html
> and provide commented, minimal, self-contained, reproducible code.
>