Hi,
I have set up sth very similar to the example "efcbq" in TC. Here
is my
network setup:
[Host1]---------eth0[router]eth1----------[Host2]
I send udp traffic from Host1 to Host2, passing thru router. I run the efcbq
code on dev eth1. After that, i run "tc -s qdisc". For each of the
class
(pfifo for EF; red for BE), there are parameters "drop" and
"overlimit". For
the drop parameter, is it supposed to mean how many packets is drop by the
class. Eg: if i limit EF to be 3Mbps, and i send 4Mbps, shouldn''t i
supposed
to see some number in the drop parameter? But i only see zero for the drop
parameter. Another thing, for the paramter "sent 10000 packets" shown,
does
it mean that i should also receive 10000 packets in Host2? I have packet
loss from router to Host2. So, in Host2 i do not get 10000 packets. Any
advice?
How do you guys graph in order to get statistics like delay and throughput?
Which software, at the router or Host2 side?
Thanks in advance.
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
