New installation of 4.8-RELEASE on a new system.
Installed XFree86 from packages:
XFree86-4.3.0,1 X11/XFree86 core distribution (complete, using
mini/m eta-po
Running "XFree86 -configure" fails, locking the keyboard (but not the
system) and making the system squeal like a pig.
The last few lines of the XFree86.0.log
(II) Module int10: vendor="The XFree86 Project"
compiled for 4.3.0, module version = 1.0.0
ABI class: XFree86 Video Driver, version 0.6
(II) NV(0): initializing int10
(==) NV(0): Write-combining range (0xa0000,0x20000) was already clear
(==) NV(0): Write-combining range (0xc0000,0x40000)
(WW) NV(0): Bad V_BIOS checksum
(II) NV(0): Primary V_BIOS segment is: 0xc000
(==) NV(0): Write-combining range (0x0,0x1000) was already clear
pciconf reports the following:
none2@pci1:0:0: class=0x030000 card=0x040910b0 chip=0x018110de
rev=0xa2 hdr=0x00
vendor = 'NVIDIA Corporation'
device = 'GeForce4 MX 440SE with AGP 8X [NV18]'
class = display
subclass = VGA
No XFree86Config.new is written out.
Any ideas or suggestions would be greatly appreciated!
Thanks!
-- Scott
