From: israel.garcia at cimex.com.cu> I want to install CentOS 4.0 on my new server (two SATA hdds, Intel 865
> mainboard), now, I want to configure a RAID 1 using this hardware..., my
> question is:
> 1. Setting up a RAID 1 on SATA hdds is different from a normal hdds
> (PATA)?
SATA channels are designed to be legacy compatible with software for
legacy ATA channels, _unless_ you put them in Advanced Host Controller
Interface mode. In AHCI, instead of individual I/O ports, the system
presents a single device of up to 32 devices, along with some capabilities
for each drive (e.g., native command queuing, NCQ).
In legacy ATA mode, each drive is assigned a device.
AHCI support varies in Linux right now (i.e., don't use yet!).
True Hardware ATA RAID controllers provide queuing natively, since
they are queuing with an on-board intelligence (microcontroller or ASIC),
and not just a "dumb" interface to the drive. In essence, the
"intelligence"
moves from the driver to the on-board firmware, and the OS driver becomes
"dumb" (and GPL as a result ;-).
> 2. Is there some SATA RAID Linux Howto available?
The same HOWTOs/documentation for LVM/MD applies regardless of
ATA, SATA or SCSI when using software LVM and/or MD.
--
Bryan J. Smith mailto:b.j.smith at ieee.org