asterisk users - Feb 2011 - First go at a stock 1.8 install -- where's DAHDI?

Hi, all.  I've finally made the jump from 1.4 to 1.8.  I've installed
everything (I think), my Sangoma card initializes right... but there's no
"dahdi" command -- not from the base, nor as a subset of the
"core"
commands.  I've got my channels configured in my chan_dahdi.conf file. 
What am I missing, here?

Thanks...

-Ken

On Sat, Feb 19, 2011 at 4:15 PM, Ken D'Ambrosio <ken at jots.org>
wrote:
> Hi, all. ?I've finally made the jump from 1.4 to 1.8. ?I've
installed
> everything (I think), my Sangoma card initializes right... but there's
no
> "dahdi" command -- not from the base, nor as a subset of the
"core"
> commands. ?I've got my channels configured in my chan_dahdi.conf file.
> What am I missing, here?
>
> Thanks...
>
> -Ken
>
What version of dahdi do you have installed? I would try using the
latest version 2.4.0. It is important to compile and install in the
correct order. I usually do dahdi, libpri, asterisk, and then wanpipe.

Ryan

On Sat, Feb 19, 2011 at 04:15:15PM -0500, Ken D'Ambrosio
wrote:
> Hi, all.  I've finally made the jump from 1.4 to 1.8.  I've
installed
> everything (I think), my Sangoma card initializes right... but there's
no
> "dahdi" command -- not from the base, nor as a subset of the
"core"
> commands.  I've got my channels configured in my chan_dahdi.conf file. 
> What am I missing, here?
This may be caused by one of two things:

1. You have not built chan_dahdi.so
2. You built chan_dahdi.so, but it has failed to load (normally because
   of broken configuration)

Try running the following from the Asterisk CLI (rasterisk):


  module unload chan_dahdi.so

That one will likely give an error message. Ignore it.

  module load chan_dahdi.so

What error do you get from that?

-- 
               Tzafrir Cohen
icq#16849755              jabber:tzafrir.cohen at xorcom.com
+972-50-7952406           mailto:tzafrir.cohen at xorcom.com
http://www.xorcom.com  iax:guest at local.xorcom.com/tzafrir