Hi ! Sorry if this is a long post... I had this setup for about a year without problems : Network A <-> wrv200 <-> internet <-> wrv200 <-> net b The 2 networks are linked with an ipsec vpn. The 2 internet connections are with the same cable company to minimize latency, both separates /24 subnets. On network A, I got 2 computers, a single sip phone (aastra 9112i). On network B, I got a linux box acting as smb domain controler and many other thins, another linux box that only do an asterisk server, 4 computers, 3 sip phones (2 aastra 9112i and one 480i ct), 1 analog ATA for the alarm system, an internet point of sale terminal, that's about it. The asterisk server is connected to the PSTN with a VOIP provider trough IAX. All of this was working fine. Since the last couple of months, we had some qos problems with the exterior. The sound was choping up randomly. With what I can do with the linksys wrv200, I was limited. I also had some filesystem issues that made the asterisk server locks up from time to time. So I wanted to reformat the server and re-install it on a ssd drive. So for the time of the re-format, I installed asterisk on my smb server, and re-copied /etc/asterisk, /var/spool/asterisk and /var/lib/asterisk to it. When I arrived at home, the externel power supply of the little shuttle box refused to power up. So I ended up building a new computer from scratch. This new server will be acting as asterisk server and router, replacing the wrv200 from network b (demoting it to wireless access point and switch). Last sunday, I installed the server, re-copying the 3 folders of asterisk in the same maner. I then had a hard time making the phones register to the server. I always had "no service" with the mwi light steady on. I finaly got the phones to register, I'm still not sure exactly what I did to make it work. And the phone on network A didn't work wither. I'll get to that one later. The linksys pap2t ata didn't had the problem, it registered right as I started the server. On the phones on network B, since then I get the MWI light come on momentarely, with the "no service" on the display, and then all comes back to normal. But all phones can make and receive calls. For the remote phone, for those familiar with ipsec vpns, it's a net to net connection. So, the gateway cannot reach the computers on the network on the other side. So I had to add a static route on my router/asterisk server to be able to reach the phone on the other side. It was able to register for some time, but the next morning it was "no service", and I wasn't able to make it work again. I ended up connecting the phone trough the externel interface of the router/asterisk server. So, my questions : Why is the phones are constatly showing "no service" with the light flashing ? Is there a way for the remote phone from net A to connect properly trough the vpn ? Thanks for any hints, Niolas