hello everybody ,
i got a test setup with
lanphone 101 connected to *
and a welltech fxo 3802 also to *
the extensions are configure so that i can dial from the lanphone to
the fxo.
although once on the FXO and having the dialtone, no of my dtmf
dialing is being processed on the FXO. It keeps giving me the
dialtone constatly.
Everything is configured as outband DTMF (we tried also doing inband
but it was doing the same)
We tried to call the echo test application to check if the # would
close the connection, and it does. So dtmf from lanphone to * seems
to work OK.
We also tried to configure a extension like
dial(SIP/FXO,50,D(0022156765))
it does connect to the fxo; but the dtmf isn't being processed...
(keeps giving me the dialtone)
Anybody got a similar problem like this, and a prob. solution ?
the sip.conf for each unit looks like
[home]
disallow=all
allow=ulaw
type=friend
secret=****
username=home
host=dynamic
context=default
nat=yes
dtmfmode=rfc2833
--
Best regards,
Danny mailto:dannyz@belgonet.com
belGOnet.com a Euro-pictures division - internet solutions
place princesse elisabeth 9/11 - 1030 Brussels - Belgium
Tel : +32-(0)2-215.67.65 - Fax : +32-(0)2-215.66.65
domains - hosting - hardware - VoiP - consultancy - backuping
CISCO - HP/COMPAQ - SUN - EMC - JUNIPER - IBM - DELL - NORTEL
No legal consequences can be derived from the contents of the email
neither is belGOnet.com committed to them. The content of this email
is exclusively intended for adressee(s) and information purposes.
belGOnet.com accepts no liability for any damage resulting from the
use and/or acceptation of the content of this email.
