My home * system I use for test/dev stuff has recently started to miss all calls. I have two of the "X100P" boards from x100p.com that are about a year old in it. They both have worked in the past no problem. At some point in the past couple of weeks they both stopped answering the phone. I don't have a specific date because only I and a couple of other people call in on those lines. Dialing out on the channels works just fine. I took the opportunity to reinstall 1.4.0 (zaptel and asterisk) to see if maybe it was a software issue, and I also swapped around the analog lines and made sure that they were still ringing if plugged into other equipment. I checked with ztmonitor and you can see the RX level go up when the ring comes in, but still no detection in *. I don't get the "Starting simple switch" message or anything like that anymore. I blew away my zapata.conf file and tried an example from the mailing list with no success. I tried turning on distinctive ring detection to see if maybe a subtle change in cadence was causing the problem but it did not detect anything either. I can provide config files upon request, I just don't want to clutter up the mailing list with them if it turns out it's not needed. Any suggestions would be wonderful. I am planning on buying an TDM400P based card but for the time being I'm unemployed and would like to avoid the expense. Also if my problem turns out to be software based I'd rather not have shelled out the money on hardware to fix it. Thanks -Scott
On Fri, Feb 16, 2007 at 05:59:39PM -0800, Scott Call wrote:> My home * system I use for test/dev stuff has recently started to miss > all calls. > > I have two of the "X100P" boards from x100p.com that are about a year > old in it. They both have worked in the past no problem. > > At some point in the past couple of weeks they both stopped answering > the phone. I don't have a specific date because only I and a couple > of other people call in on those lines. Dialing out on the channels > works just fine. > > I took the opportunity to reinstall 1.4.0 (zaptel and asterisk) to see > if maybe it was a software issue, and I also swapped around the analog > lines and made sure that they were still ringing if plugged into other > equipment. > > I checked with ztmonitor and you can see the RX level go up when the > ring comes in, but still no detection in *.Try setting both modules: zaptel and wcfxo, with debug=1 . Anything on the kernel logs? (make sure you log kernel debug messages. What Linux distribution is it?)> > I don't get the "Starting simple switch" message or anything like that > anymore.Can you try setting the debug level to , say, 5[1], and log debug messages (in logger.conf). Do you see anything? [1] What's the maximal sensible value for debug and for verbose? -- Tzafrir Cohen icq#16849755 jabber:tzafrir@jabber.org +972-50-7952406 mailto:tzafrir.cohen@xorcom.com http://www.xorcom.com iax:guest@local.xorcom.com/tzafrir