I'm still a learning but I purchased a dph-140s to test with AAH 1.5. I think this is a rebadged ACT P104SLD which others seem to have working with *. It seems to be configured and registered similarly to the softphones I've been using just fine, but it does not receive or send audio (it will send audio to vm), or perform the loopback test. It seems to signal and receive calls fine. The phone is on an internal lan with a local aah server. I'm merely guessing but it seems like the rtp side is not communicating properly. The codec selected is ulaw as in the config, I changed what they call "media" port from 41000 to 10000, to no avail. Does anyone have a fully working dlink phone with aah, or particularly this model? It seems very close to working. The puzzing thing to me is you can never hear any audio (tones are ok), and the audio is heard in a vm message. The phone is pretty decent otherwise so any tips would be appreciated. Thanks, Dale
Interestingly this phone works fine if I configure it for broadvoice directly (bypassing my local AAH). All the software sip phones seem to work fine with aah. The phone does not seem to know what to do if I leave the "outbound sip proxy" fields blank. And itt probably does the wrong thing if I put the address of my aah server. Neither setting results in voice traffic going to the phone. With the soft sip phones, leaving the outbound proxy fields blank is apparently the way to go with a local aah server. Any ideas how to solve this?> I'm still a learning but I purchased a dph-140s to test with AAH 1.5. I > think this is a rebadged ACT P104SLD which others seem to have working with > *. It seems to be configured and registered similarly to the softphones I've > been using just fine, but it does not receive or send audio (it will send > audio to vm), or perform the loopback test. It seems to signal and receive > calls fine. The phone is on an internal lan with a local aah server. > > I'm merely guessing but it seems like the rtp side is not communicating > properly. The codec selected is ulaw as in the config, I changed what they > call "media" port from 41000 to 10000, to no avail. Does anyone have a fully > working dlink phone with aah, or particularly this model? It seems very > close to working. > > The puzzing thing to me is you can never hear any audio (tones are ok), and > the audio is heard in a vm message. The phone is pretty decent otherwise so > any tips would be appreciated.