asterisk users - May 2005 - 2 x Eicon BRI ISDN devices (UK)

Hi
 
I have installed 2 x Eicon BRI ISDN cards into a Suse 9.2 server.  We can
use all 4 lines for out going calls fine, but on incoming we can only use 2.
On calling in using the main msn, the 3rd line gives a an engaged signal.

I have unplugged 1 of the cards, and the other card takes the 2 calls.  I
then swapped this around, and this also works fine.  But when using both
cards, we can only use 2 line in.

Any ideas???

Rgds

On Wed, 18 May 2005, Lee Norvall wrote:
> Hi
>  
> I have installed 2 x Eicon BRI ISDN cards into a Suse 9.2 server.  We can
> use all 4 lines for out going calls fine, but on incoming we can only use
2.
> On calling in using the main msn, the 3rd line gives a an engaged signal.
> 
> I have unplugged 1 of the cards, and the other card takes the 2 calls.  I
> then swapped this around, and this also works fine.  But when using both
> cards, we can only use 2 line in.
There are two possibilities:

1) your Telco doesn't send the 3rd call to your other line.
   You can verify that by using
    divactrl mlog -c 1 -o          (diva_idi module must be leaded)
   and see if an incoming call is shown.
   (use -c 2 for the second card)

2) your configuration of chan_capi is not correct and the 3rd call is 
   ignored/rejected.

If you don't use DIVA Server cards with CAPI, forget this mail.

Armin