Is there a configuration difference for clone X100P cards versus "compatible"? I have a similar problem to what David Shaw posted earlier today. 0.5 installed OK, but mine just with one X100P clone. Default config files, edited zapata.conf per the FAQs so it includes the line channel => 1 without the semicolon. Any outgoing call attempt returns "all circuits are busy" announcement. Edited extensions_additional.conf so the outgoing macro calls channel 1 instead of group 1, no change (except the CLI reports it's dialing Zap/1 instead of Zap/g1) Console reports that it's executing Dial/Zap/g1/2345678 where that's the number I dialed, and then "everyone is busy/congested..." zttool reports Generic Clone Board 1, no alarms, internally clocked, no misses or violations. ztcfg -vvvv reports Channel map: Channel 01: FXS Kewlstart (Default) (Slaves: 01) 1 channels configured. Incoming calls are not answered. I uncommented the debug=yes line in /etc/sysconfig/zaptel, and now I can see RING! NO RING! etc when the incoming line is ringing, and NO BATTERY! BATTERY! after it stops. But no activity on the console CLI when this is happening. Probably something simple and stupid, but I can't see it. Anyone else with this problem?
Did you go into AMP and configure some place for incomming calls to go? --- David Josephson <dlj@altaphon.com> wrote:> Is there a configuration difference for clone X100P > cards versus > "compatible"? I have a similar problem to what David > Shaw posted earlier > today. 0.5 installed OK, but mine just with one > X100P clone. Default > config files, edited zapata.conf per the FAQs so it > includes the line > channel => 1 > without the semicolon. > > Any outgoing call attempt returns "all circuits are > busy" announcement. > > Edited extensions_additional.conf so the outgoing > macro calls channel 1 > instead of group 1, no change (except the CLI > reports it's dialing Zap/1 > instead of Zap/g1) > > Console reports that it's executing > Dial/Zap/g1/2345678 where that's the > number I dialed, and then "everyone is > busy/congested..." > > zttool reports Generic Clone Board 1, no alarms, > internally clocked, no > misses or violations. > > ztcfg -vvvv reports > Channel map: > Channel 01: FXS Kewlstart (Default) (Slaves: 01) > 1 channels configured. > > Incoming calls are not answered. I uncommented the > debug=yes line in > /etc/sysconfig/zaptel, and now I can see RING! NO > RING! etc when the > incoming line is ringing, and NO BATTERY! BATTERY! > after it stops. But > no activity on the console CLI when this is > happening. > > Probably something simple and stupid, but I can't > see it. Anyone else > with this problem? > _______________________________________________ > Asterisk-Users mailing list > Asterisk-Users@lists.digium.com >http://lists.digium.com/mailman/listinfo/asterisk-users> To UNSUBSCRIBE or update options visit: > >http://lists.digium.com/mailman/listinfo/asterisk-users>__________________________________ Do you Yahoo!? Yahoo! Mail - 250MB free storage. Do more. Manage less. http://info.mail.yahoo.com/mail_250