asterisk users - Dec 2003 - E100P configuration

Hi !

I am trying to configure two E100P cards, but I am a bit confused with
zapta.conf in what I am trying to achieve.

The * will be connected to a pstn switch with two E1 PRI lines. The E1 lines
will be used for incoming calls as well as outgoing calls.

My problem now is what to put in zapta.conf, I would like to group all
channels from both cards together (if that's possible). Does this make sense
?

context=default
switchtype=euroisdn
signalling=pri_net
;pridialplan=national
overlapdial=yes
group=1
channel => 1-15,17-31,32-46,48-62

what does "channel include" ? all the channels d and b ?

Thanks for your help.

Dave

Hi-

Not sure that I understand your question about grouping, but here is what I
use for 2 E1's connected to a private switch (in addition to the other
parameters)  Note that I use the pri_cpe ("customer premise
equipment")
setting.  The defined channels act as one big group of 60 channels, if
that's what you mean.  Your telephone company will define the call
distribution for your incoming calls:

pridialplan=unknown
context=incoming
usecallerid=yes
group=1

signalling=pri_cpe
channel => 1-15,17-31
channel => 32-46,48-62

Regards,
Scott

Scott M. Stingel 
Emerging Voice Technology Inc.
Palo Alto, California and London, England

Email:          scott "at" evtmedia.com   
URL:            www.evtmedia.com  



-----Original Message-----
From: asterisk-users-admin@lists.digium.com
[mailto:asterisk-users-admin@lists.digium.com] On Behalf Of Dawid Mielnik
Sent: Tuesday, December 30, 2003 11:50 AM
To: asterisk-users@lists.digium.com
Subject: [Asterisk-Users] E100P configuration


Hi !

I am trying to configure two E100P cards, but I am a bit confused with
zapta.conf in what I am trying to achieve.

The * will be connected to a pstn switch with two E1 PRI lines. The E1 lines
will be used for incoming calls as well as outgoing calls.

My problem now is what to put in zapta.conf, I would like to group all
channels from both cards together (if that's possible). Does this make sense
?

context=default
switchtype=euroisdn
signalling=pri_net
;pridialplan=national
overlapdial=yes
group=1
channel => 1-15,17-31,32-46,48-62

what does "channel include" ? all the channels d and b ?

Thanks for your help.

Dave

_______________________________________________
Asterisk-Users mailing list
Asterisk-Users@lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users

Hello

I have been buttling to get a Valiant VCL-30 E1 channel bank multiplexer 
talking to asterik's E100P card.

The Spec for the VCL says this:

Coding: hdb3
Signalling: CAS
Timing: can be internal, external sync
Nominal Impedance: 120ohm balanced, 75ohm unbalanced
supports euroisdn

In the zaptel.conf file, I have:
span=1,1,0,cas,hdb3,crc4

The LED on the VCL indicates that I have a "Remote Frame Alarm"
The E100P also has an alarm on it.

Could anyone point me to something else I may need to configure to get this 
device working with *

Thank you

Anthony