asterisk users - Sep 2003 - Config TE410P + TDM400

When configuring a TE410P which is only attached to a single E1 together
with a TDM400, how should one count the channels for the next Zap interface?

Must I put 4 span lines in zapata.conf and define all channels up to 124?
thus having the TDM400's start at 125? Or can I comment out the 3 spans I
don't use and start at channel 32 for the TDM400? (this would get nasty when
adding extra lines, but would stop asterisk from trying to look at E1's
which are not connected)

At 18:28 26-9-2003 +0200, you wrote:
>When configuring a TE410P which is only attached to a single E1 together
>with a TDM400, how should one count the channels for the next Zap interface?
>
>Must I put 4 span lines in zapata.conf and define all channels up to 124?
>thus having the TDM400's start at 125? Or can I comment out the 3 spans
I
>don't use and start at channel 32 for the TDM400? (this would get nasty
when
>adding extra lines, but would stop asterisk from trying to look at E1's
>which are not connected)
I have an E400P with just one active span. It will work just fine with the 
span-lines commented out :-)


Florian