You might be experiencing a PCI Master Abort. Type dmesg.
If you see PCI Master Abort, then that is your problem. If
you don't, then I'm out of ideas.
-Derek
-----Original Message-----
From: asterisk-users-admin@lists.digium.com
[mailto:asterisk-users-admin@lists.digium.com] On Behalf Of Brad Bergman
Sent: Thursday, July 10, 2003 11:52 AM
To: asterisk-users@lists.digium.com
Subject: [Asterisk-Users] TDM10B - Dies after a few hours
I've been having trouble with a TDM10B that I installed a few days ago.
At first I could not modprobe it at all (getting the errors below). I
switched the X100P that was also installed (with a Motorola chip) with
one
with a Tiger-something chip, and then everything starts up okay.
However, after a few hours, the FXS port dies (no battery or anything),
and if I try to rmmod & modprobe again, I can't.
modprobe wcfxs
/lib/modules/2.4.18-14/misc/wcfxs.o: init_module: No such device
Hint: insmod errors can be caused by incorrect module parameters,
including invalid IO or IRQ parameters.
You may find more information in syslog or the output from dmesg
/lib/modules/2.4.18-14/misc/wcfxs.o: insmod
/lib/modules/2.4.18-14/misc/wcfxs.o failed
/lib/modules/2.4.18-14/misc/wcfxs.o: insmod wcfxs failed
I have seen a couple of references to this or similar problems, but no
solution...
http://lists.digium.com/pipermail/asterisk-users/2003-May/011171.html
http://lists.digium.com/pipermail/asterisk-users/2003-May/012891.html
Anyone have any ideas? I realize that there are some problems with the
board in general, but this one doesn't really seem similar.
Thanks,
Brad
_______________________________________________
Asterisk-Users mailing list
Asterisk-Users@lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users