-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hi, I'm attempting to hook up the E400P card to a Siemens ISDN module. I have no knowledge of these Siemens products, so I'm acting on what I've been told about it. The Siemens side is configured to "ISDN30: ECMA QSIG". The Siemens manual states the card provides 30 ISDN B-channels which can be used for trunking or networking. Some guy at Siemens told me that my end probably would have to be acting as a slave because of the clock, what ever that means. How should Iconfigure my E400P wildcard according to the above info? Can it be done? I'm pretty lost. - -- Regards, Tais M. Hansen ComX -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.2 (GNU/Linux) iD8DBQE+3H4G2TEAILET3McRAso8AJ9QS7w4atUaZsu4is8wkszuwKpArwCfYxs/ V5qw5penjkKzY/hQlUlX/30=GfQa -----END PGP SIGNATURE-----
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 On Tuesday 03 June 2003 12:52, Tais M. Hansen wrote:> The Siemens side is configured to "ISDN30: ECMA QSIG". The Siemens manual > states the card provides 30 ISDN B-channels which can be used for trunking > or networking.Okay, I've done even more studying on these matters. It would seem QSIG is not supported by E400. There're a bunch of other protocols to chose from, but nothing that rings a bell. My work has just become much more difficult. :( - -- Regards, Tais M. Hansen ComX -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.2 (GNU/Linux) iD8DBQE+3IrN2TEAILET3McRAi7EAJ9LKWp/hQPnaLYnpp9bN4WgcbVaVACfXZIk IumHgdhFn7VvKwW/AQKRJJE=R7WZ -----END PGP SIGNATURE-----
Mark Spencer wrote:>>You could, of course, contribute the changes needed to make libpri do >>Q.SIG, and everyone will benefit. :-) >> >> > >What all is required for Q.SIG? >Another bunch of Q.931 type messages, basically. It builds on Q.931 to add PBX (i.e. private network) specific features. Regards, Steve
Steve Underwood wrote:> Mark Spencer wrote: > >>> You could, of course, contribute the changes needed to make libpri do >>> Q.SIG, and everyone will benefit. :-) >>> >> >> >> What all is required for Q.SIG? >> > Another bunch of Q.931 type messages, basically. It builds on Q.931 to > add PBX (i.e. private network) specific features.you can get the specs from ECMA, the relevant doc is: http://www.ecma-international.org/publications/standards/ECMA-165.htm and the pdf should be free in any sense, from the web page: "All ECMA publications are available, free of charge and freely copyable, as files or in printed form." here it is the link, awfully slow: http://www.ecma-international.org/publications/files/ecma-st/Ecma-165.pdf bye