R help - Jun 2003 - core dump on solaris 2.9

Hello,

I have compiled R 1.7.1 using gcc 3.2.2 and these configure options:
./configure --prefix=/opt --with-readline --with-x --without-gnome 

It compiled and runs fine, except when "plot(1:10)" is run in R.  The 
plot appears for an instant, then the graphics window closes and the R 
session ends with the message ``Bus Error (core dumped)''.

I'm not sure what to do... any suggestions?  Please mail me directly,
since I'm not subscribed to this list.

Thanks,

Brent

[I presume this is sparc-Solaris, but you did not say.]

Please do as the INSTALL file asks and read the R-admin manual: this *is*
documented there!  That version of gcc is obselete, and unusable on
sparc-Solaris.  You will have to find a working compiler: if all else
fails, try turning optimization off completely (for C, C++ and Fortran).

On Sun, 22 Jun 2003, Brent Kearney wrote:
> I have compiled R 1.7.1 using gcc 3.2.2 and these configure options:
> ./configure --prefix=/opt --with-readline --with-x --without-gnome 
> 
> It compiled and runs fine, except when "plot(1:10)" is run in R. 
The
> plot appears for an instant, then the graphics window closes and the R 
> session ends with the message ``Bus Error (core dumped)''.
> 
> I'm not sure what to do... any suggestions?  Please mail me directly,
> since I'm not subscribed to this list.

-- 
Brian D. Ripley,                  ripley at stats.ox.ac.uk
Professor of Applied Statistics,  http://www.stats.ox.ac.uk/~ripley/
University of Oxford,             Tel:  +44 1865 272861 (self)
1 South Parks Road,                     +44 1865 272866 (PA)
Oxford OX1 3TG, UK                Fax:  +44 1865 272595