R help - May 2003 - Rcmdr on Debian

Hi,

I've been able to run Rcmdr on Debian-Woody without too much problems,
just to load first the tcltk and car libraries. The issue is that after
leaving R I'm not able to see at the prompt any character like 'ls',
but
the unix instructions are executed, don't know why the visualization of
the unix commands is cancelled.

Antonio Rodriguez

<arv at ono.com> writes:
> Hi,
> 
> I've been able to run Rcmdr on Debian-Woody without too much problems,
> just to load first the tcltk and car libraries. The issue is that after
> leaving R I'm not able to see at the prompt any character like
'ls', but
> the unix instructions are executed, don't know why the visualization of
> the unix commands is cancelled.
This can happen even without the tcltk stuff. Not quite sure why (most
likely, it is readline-related), but the way out is to type "stty
sane" at the shell prompt.

-- 
   O__  ---- Peter Dalgaard             Blegdamsvej 3  
  c/ /'_ --- Dept. of Biostatistics     2200 Cph. N   
 (*) \(*) -- University of Copenhagen   Denmark      Ph: (+45) 35327918
~~~~~~~~~~ - (p.dalgaard at biostat.ku.dk)             FAX: (+45) 35327907