Now tackling sending the UPS commands to have it turn off and back on (with some
delay), I'm just putting this out there to make sure I'm on the right
track. I want to design this to be as close as possible to "industry
standard", or at least concensus.
Looking through the other HU_TYPE_CMDs out there, it seems that most UPSs use
"UPS.PowerSummary.DelayBeforeShutdown" for load.off.delay, and
"UPS.PowerSummary.DelayBeforeStartup" for load.on.delay. Belkin
appears to use custom codes (reserved for vendors), which I know I could do, but
guess I don't see the reason for doing so yet.
So basically, when someone uses load.off.delay as a command to the UPS, then the
value they pass through is how many seconds they want the UPS to wait before
disconnecting the power to the CPU. That is the time in which you HOPE the
system shuts down successfully.
You also (can) pass in load.on.delay, which should be a value larger than
load.off.delay. That tells the UPS that even if wall power comes back, do not
switch on the UPS load until X seconds have passed. This makes sure the system
has fully shut down, and power is removed...before it is applied again. This
ensures that the system will startup again.
Have I got the right idea? It seems like those two commands will take care of
most I need to have the UPS do.
Sincerely,
Rob Groner
Software Engineer
RTD Embedded Technologies, Inc.
ISO9001 and AS9100 Certified
Ph: 814-234-8087
www.rtd.com<http://www.rtd.com/>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://lists.alioth.debian.org/pipermail/nut-upsdev/attachments/20150311/bae33e77/attachment.html>
