I've searched the archives a bit and have not really come up with a good answer to my queries. I have * running on a RH9 box behind a LinkSys NAT box. I can talk with iConnectHere outbound just fine. I am trying to configure an inbound Xten softphone from outside. I have that user set as NAT in sip.conf (seems to help), but I still cannot establish a full session. I think the problem comes when * sends info about the RTP connection, it passes the nonroutable address. Is there a ways to tell it to use the firewall IP address for users coming in through that address(and the firewalls nonroutable address). On the flip side, I have run out of port forwarding slots on my LinkSys, so I am trying to resurrect my old startup's SonicWall PRO. They indicate they support SIP, but they do not elaborate upon that at all. Anyone have comments concerning the SW & SIP? So far I have an ATA-186, a DG104S, as well as a TDM400P and X100P with service from iConnectHere. I hope to ship either the ATA-186 or DG104S to Australia when I figure out how to deal with them remotely. Thanks, -- John
Your best bet is probably the Sonicwall cos IIRC they don't use NAT but rather a packet forwarding bridge which means that you will be able to assign the * box a pulic IP address and then open the ports required..> > I've searched the archives a bit and have not really come up with > a good answer to my queries. > > I have * running on a RH9 box behind a LinkSys NAT box. I can talk > with iConnectHere outbound just fine. I am trying to configure an > inbound Xten softphone from outside. I have that user set as NAT in > sip.conf (seems to help), but I still cannot establish a full session. > I think the problem comes when * sends info about the RTP connection, > it passes the nonroutable address. Is there a ways to tell it to use > the firewall IP address for users coming in through that address(and the > firewalls nonroutable address). > > On the flip side, I have run out of port forwarding slots on my LinkSys, > so I am trying to resurrect my old startup's SonicWall PRO. They indicate > they support SIP, but they do not elaborate upon that at all. Anyone have > comments concerning the SW & SIP? > > So far I have an ATA-186, a DG104S, as well as a TDM400P and X100P with > service from iConnectHere. I hope to ship either the ATA-186 or DG104S > to Australia when I figure out how to deal with them remotely. > > Thanks, > > -- John > > > _______________________________________________ > Asterisk-Users mailing list > Asterisk-Users@lists.digium.com > http://lists.digium.com/mailman/listinfo/asterisk-users-- ______________________________________________ http://www.linuxmail.org/ Now with e-mail forwarding for only US$5.95/yr Powered by Outblaze