Okay so for some reason my Opensolaris 106 installation quit booting
properly (completely seperate problem). At this point I was still able
to boot into safe mode, but not into a normal desktop session.
First a disk failed, I replaced this disk with another. The array
completely resilvered. I was able to scrub the array, etc.
Second, I added 2 more disks, issuing the replace command to use these
2 new disks instead of 2 of the old disks (so I replaced 2 good IDE
disks with 2 good SATA disks, all 4 disks were attached at the same
time, thus the reason for multiple replace''s at one time).
The resilver completed successfully. I was able to scrub the array. I
exported the array, rebooted, imported the array, and scrubbed it
again - no problems.
Now I removed the 2 IDE drives, rebooted again, was able to import the
array, scrub it, etc no problems.
(Until this point everything has been done in safe mode, and the
replacing stuff never went away although the scrub''s completed fully,
and all the origional drives (that had been replaced) have been
removed).
SO I then proceed to install opensolaris 109 (in order to get a fully
booting/working machine again). Now when I zpool import I get the
following:
# zpool import
pool: tank
id: 15417328101188042571
state: UNAVAIL
action: The pool cannot be imported due to damaged devices or data.
config:
tank UNAVAIL insufficient replicas
raidz1 ONLINE
c1t1d0 ONLINE
c3t0d0 ONLINE
c2t0d0 ONLINE
c4t1d0 ONLINE
c1t0d0p2 ONLINE
raidz1 UNAVAIL corrupted data
c4t7d0 ONLINE
c4t6d0 ONLINE
replacing ONLINE
13069118156582972341 ONLINE
c2t1d0 ONLINE
replacing DEGRADED
11144084490198638692 UNAVAIL cannot open
c5t0d0 ONLINE
replacing ONLINE
3239645952837551668 ONLINE
c5t1d0 ONLINE
c4t0d0 ONLINE
c4t5d0 ONLINE
c4t2d0 ONLINE
c4t4d0 ONLINE
c4t3d0 ONLINE
#
Everything shows as online except for one vdev (that is currently
replacing), so I don''t understand why it says "insufficient
replicas"
instead of "DEGRADED"
Any help appreciated.
Thanks in advance,
-mike
--
Michael Dupree jr.