I am having one hell of a time converting an XP SP3 x86 installation to bootable image that Xen can deal with (then again I did mention this was XP) I am running Xen under Centos 5 x64 (I can provide "uname -a" if that helps) and trying to boot XP. So I how got to where I am is as follows : 1) I dumped a disk that had XP on an NTFS to a file using dd starting the dump to begin at offset 63... dd if=/dev/sdd1 of=/media/disk1/xp3.img offset=63 2) I then run fdisk on the file and set up a partition (actually the 1st partition) to being at sector 63 to the end of the disk. There are various tricks to do this a) using losetup to map a loopback device to the file and then running fdisk on that loopback device OR b) just passing the file as an arg to fdisk. At the end of this fdisk -u -l /media/disk/xp3.img show me I have one partition that being at offset 63 and it''s bootable and it''s type 7 (HPFS/NTFS). 3) I set up my guest using virt-manager, give it 2GB memory, and tell it to run fully virt under Xen_64, and giving it the XP install cd. The guest then boots and I go into the recovery console. The console sees my windows installation (C:\windows) and I log into it. I then run "fixmbr" and every this is happy so I exit. At this point the guest restarts and the console window says it''s booting but hangs. The cpu meter for the guests goes up to about 50% and sits there and until I shutdown the guest using virt-manager. The XP splash screen NEVER comes up. Any takers on how to debug this or suggestions ? Thanks Mike _______________________________________________ Xen-users mailing list Xen-users@lists.xensource.com http://lists.xensource.com/xen-users