similar to: 2-3 uplinks, nat and failover...is it possible?

Hello, Since I could not figure out my previous problem, let me ask in a different way. I have 3 networks inside my LAN. They are 172.16.55.0/24 , 172.16.56.0/24 and 172.16.57.0/24 respectively. They all use eth0 as an alias. I also have 2 uplinks to different ISPs. One of them is leased line and the other one is ADSL. One of my uplink is 81.8.120.18/30 with gateway 81.8.120.17 on eth1 and the

Hello I am using linux box as a network loadbalance router. ----------------- ------------ |LAN| - |eth0 eth1(1.1.1.2) | DSL1 ------- |DSLAM (1.1.1.1) | | eth2(1.1.1.10) | DSL2 ------- |DSLAM (1.1.1.9) | ---------------- ------------ But I have a

Dear folks: First of all, thanks for a great product and please do keep up your fine job with samba. As a humble contribution to your project, below is a patch to configure.in that allows libsmbclient.so to be correctly built in my system (Mac with Mac OS X). I hope this to be useful. I also noted that the generated Makefile, did not correctly install the library as the 'install'

https://bugzilla.netfilter.org/cgi-bin/bugzilla/show_bug.cgi?id=72 Summary: ICMPs sent by REJECT are not getting SNAT'd Product: netfilter/iptables Version: linux-2.4.x Platform: i386 OS/Version: RedHat Linux Status: NEW Severity: normal Priority: P2 Component: NAT AssignedTo:

https://bugzilla.netfilter.org/cgi-bin/bugzilla/show_bug.cgi?id=73 Summary: ICMPs sent by REJECT are not getting SNAT'd Product: netfilter/iptables Version: linux-2.4.x Platform: i386 OS/Version: RedHat Linux Status: NEW Severity: normal Priority: P2 Component: NAT AssignedTo:

Hi list, After several tries to understand the subtil description in the h323.conf to be able to make the next scenario I was presented the following error messages by asterisk. Can somebody tell me please what I am doing wrong. Scenario: Gatekeeper (h323) --> Asterisk PBX -->(h323) Gateway Endpoints are connected to Gatekeeper. Call does come in like 999931235650087 with codec g711

Hi Taner I doubt that the change of routes does not affect your connection, because this is normal practise with carriers (BGP or least cost routing) and usually it has no impact on the enduser, as it happens in milliseconds. My personal thinking is, that your ADSL Provider disconnects you once or twice a day to unload the DSLAM port and sometimes, if you do not have a fixed IP address, you

Hello all, New to the list, Asterisk and this wonderful world of convergence. From reading the docs, list and websites I hopefully correctly understand that I can use a plain cheap isdn4linux supported ISDN (passive) TA to hook up the PC to the ISDN line from the telco (FXO card?). Next in the PC I also need a FXS card like a Digium TDM10B or PhoneJack so I can hook up an analog phone to it. In

DSL works by using the frequencies above 4k that were unused in POTS loops of yesterday. Load Coils, Bridge Taps, and DC taps are all devices added to lines to increase their reach and stability, unfortunately, they are DEADLY for DSL. Other problems can effect DSL service, and cause it to be 'flaky'. 1 Temperature, in Florida the large black cables are constantly beaten down by the sun,

Hi All! Been quite a few years and lots of water under the bridge but here I am back! I have a customer that has now decided they need a bit more bandwidth over and above their fixed line! They are not in a good area for ADSL because of copper theft and being a bit to far from the closest DSLAM! They have installed a wireless link and I have made certain that put it behind my simple iptables

Hi Tom, You might be right, but I don't get why my existing downloads (I guess they are on different routes) are not affected. If my ADLS provider is doing some IP adjustments (btw my IP is static) I expect everything to disconnect, not only my icecast connection. So I'll monitor my USRobotics logs today and tomorrow so see if there is something strange. Regards, On Wed, Jun 11, 2008 at

Hi, I''ve read ADSL-Bandwidth-Management-HOWTO http://www.tldp.org/HOWTO/ADSL-Bandwidth-Management-HOWTO/implementation.htm l#AEN166 and I''ve a doubt from script: [ ... ] # DNS name resolution (small packets) iptables -t mangle -A MYSHAPER-OUT -p udp -j MARK --set-mark 21 [ ... ] That is a bug ? I think that " DNS name resolution (small packets) " is better

Hello all, I have a problem with browsing and share access over an IPSEC VPN. Details follow. The network has the following configuration: There are two local networks, 172.16.57.0/24 and 172.16.59.0/24. The networks are connected over the internet by Cisco routers providing an IPSEC VPN. The VPNs are configured to route all traffic (all IP types, all ports, except broadcast and ICMP

I have three ADSL lines that I''d like to use as one big pipe to the internet. The ADSL service works by establishing a pppoe connection (the ADSL "modem" is a bridge), and each pppoe interface gets its own IP address. This means I''d have to have 4 ethernet interfaces (3 for each of the ADSL modems and 1 for the LAN) in my gateway. I''d setup the gateway to NAT

Hi, I am having problems establishing an adsl connection in dom0 (but ONLY in dom0, without xen everything is ok). Following is my setup/situation: 1. Installed clean Fedora 7 (with virtualization option selected) 2. Booted with the non-xen kernel & setup adsl. Adsl connection works without any problems. 3. Rebooted with xen kernel into dom0. 4. adsl connection can no longer be activated

Hi, i dont fully understand this sentence, could someone be so kind to expleain me it? Any router performing a shaping function should be the bottleneck on the link, and should be shaping slightly below the maximum available link bandwidth. This prevents queues from forming in other routers, affording maximum control of packet latency/deferral to the shaping device.

Has anything changed this 2 years with wine and Win snmptrap support?

Hi Maarten, Yes, I'm behind ADSL with PPPoE but I don't think it is related with my case. When my client disconnects from IceCast server for 15-20 seconds, my active downloads are not interrupted. It currently effects only the route to my IceCast server, other routes looks uneffected. I'm pinging IceCast server continuously and checking trace route periodically. It is comething like:

Hi, Everything was working fine on this 10 phone office, but for last few weeks they are complaining that audio goes blank for a few seconds during the conversation, and then comes back on. It goes blank for both parties. What are the possible causes for this to happen? -- Zeeshan A Zakaria -------------- next part -------------- An HTML attachment was scrubbed... URL:

I''ll take it from the begining... About one year ago I only had 1 IP and used wondershaper. It worked great. Now I got /27 (32 IPs) and a gw computer that talks to two ISPs via a two tunnels. See: http://www.flashdance.cx/pics/flashdance-LAN.png I _really_ have a need to do QoS on my connection, for example I host websites that uses all available upstream. When I download at the same