search for: aefirion

Hi, I'am having some problems with new mainboards and 3xHFC-S cards. The the first problem was with interrupts, I mean if HFC-S card was using interrupt i.e. 21 or higher - it didn't work. Solved by disabling APIC. However, still the driver behaves a little bit strange. If card 0 & 1 is TE and 2 is NT, TE works fine, but NT is not working at all. If card 0 is NT and 1 & 2 TE - all

hi, I am on fax-to-email system, basically taken from http://www.voip-info.org/wiki-Asterisk+Fax+to+email well, it seems that asterisk causes some problems so that it is impossible to send any fax. I.e. when I try to send a fax to asterisk (rxfax application): normalFax--->FXS(TDM400P)--->Asterisk(RxFax) it breakes up the trasmission at the beginning of sending page. The code given by

I'm trying to use a 4 port ATA that was designed for use with MGCP 1.0 / NCS 1.0 -- is the channel_mgcp compat with NCS -- anything I can do to make it compat?? This is what happens - below *CLI> mgcp reload Reloading MGCP == Parsing '/etc/asterisk/mgcp.conf': Found Use EXIT or QUIT to exit the asterisk console == MGCP Listening on 10.1.22.39:2427 == Using TOS bits 0 mgcp

I have installed Asterisk on a CentOS4 box and then installed Asterisk from CVS. I installed a Sangoma A101 and connected it to a Adtran 600 using a T1 Crossover cable. The 600 has 12 x FXS, 12 x FXO interfaces. I ran through the wanpipe install instructions and configured it, now I can run [root@altpbx asterisk]# wanrouter hwprobe ------------------------------- | Wanpipe Hardware Probe Info

Anyone knows where can I find spandsp? Official site seems permanently down... TIA, Simone.